TM 10-3930-675-24-1
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0008 00
Table 7. Error Code 1322 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1322 - Injector Circuit Failure - 6. Place ignition switch in OFF
Continued.
position. Remove rocker arm
cover
(WP
0052
00).
Disconnect injector solenoid
connector from no. 1 injector
solenoid and internal actuator
harness
from
15-pin
connector.
a. Inspect internal actuator Clean and repair connector(s) as
injector required (WP 0113 00).
harness
and
solenoid connector for dirty,
corroded, bent, broken,
pushed back, and extended
pins.
b. Check internal actuator
Remove dirt and moisture from
harness
and
injector
connector. Replace missing or
solenoid connector for dirt
damaged connector seals (WP
0113 00).
or moisture in or on
connector and for missing or
damaged connector seals.
7. Place ignition switch in OFF
position and, with rocker arm
cover removed, disconnect
actuator harness from 15-pin
connector
and
injector
solenoid wires from no. 1
injector solenoid.
a. Measure resistance from 15- a. If resistance is not as specified,
pin connector pin 1 (or A) to
repair or replace connectors
(WP 0113 00).
each injector pigtail nut that
connects the no. 1 injector b. If internal actuator harness
requires replacement, notify
(resistance to one of these
SRA.
nuts must be within
specifications). Resistance
should be less than 10 Ohms.
0008 00-26
