TM 10-3930-675-24-2
BOOM WIRING HARNESSES REPLACEMENT - CONTINUED
0220 00
REMOVAL - CONTINUED
4.
Trace wiring harnesses (4 and 5) to tophandler junction box (12) and disconnect from junction box (WP 0222 00).
5.
Remove and discard tiedown straps that secure wiring harnesses (4 and 5) together at tophandler junction box (12) end.
NOTE
Note routing of wiring harnesses through middle portion of flexible conveyer.
6.
Pull wiring harnesses (4 and 5) toward front of vehicle, pulling them through box channel (11) and flexible conveyer (7).
7.
Remove wiring harnesses (4 and 5) from vehicle.
11
4,5
12
INSTALLATION
1.
Starting from rear of flexible conveyer (7) and working toward tophandler, feed wiring harnesses (4 and 5) through mid-
dle portion of flexible conveyer and into box channel (11), until wiring harness ends reach tophandler junction box (12).
2.
Connect wiring harnesses (4 and 5) to tophandler junction box (12) (WP 0222 00).
3.
Install new tiedown straps to secure wiring harnesses (4 and 5) together at tophandler junction box (12) end.
4.
Position wiring harnesses (4 and 5) inside channels (8) along boom (6), until ends of wiring harnesses reach connection
points to chassis wiring harnesses.
5.
Connect wiring harness (4) connector (3) to chassis wiring harness connector (1). Install four screws (2).
6.
Connect wiring harness (5) connector (9) to chassis wiring harness connector (10).
7.
Secure wiring harnesses (4 and 5) to channels (8) with new tiedown straps.
0220 00-2