TM 10-3930-675-24-2
CRANKSHAFT REPLACEMENT - CONTINUED
0272 00
REMOVAL - CONTINUED
NOTE
No. 4 main bearing cap has four thrust bearings.
5.
Remove and mark two lower thrust bearings (5) for location. Mark "L" for lower and "F" or "R" for front or rear.
5
NO. 4
BEARING CAP
6.
Remove and mark two upper thrust bearings (5) in same manner.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
these procedures. Ensure that any lifting device used is in good condition and of suitable load capacity.
Stay clear of heavy parts supported only by lifting device. Failure to follow this warning may result in
injury or death to personnel.
7.
Using lifting sling and assistance, remove crankshaft (6) from cylinder block and place on work surface.
6
CYLINDER
BLOCK
0272 00-3