TM 10-3930-675-24-2
OIL PUMP ASSEMBLY MAINTENANCE - CONTINUED
0277 00
DISASSEMBLY - CONTINUED
3.
Remove driven gear and shaft (16) from oil pump body (12).
4.
Remove drive gear and shaft (17) from oil pump body (12).
16
17
12
12
ASSEMBLY
1.
Apply clean lubricating oil to drive gear and shaft (17) and install in oil pump body (12).
17
12
CAUTION
Ensure flat face of oil pump body, and not dowel pins, is resting against press table. Damage to dowel
pins may occur when installing drive gear.
2.
Place oil pump body (12) in press with front facing up and support driveshaft.
3.
Position drive gear (14) on shaft with part number facing up.
4.
Press drive gear (14) on shaft far enough to leave specified clearance. Gear-to-body clearance must be 0.37 to 0.47 in.
(9.50 to 12.00 mm).
0277 00-6