TM 5-3810-306-34
6. DETERMINE SIDE CLEARANCE BETWEEN
CONNECTING ROD AND CRANKSHAFT.
Limit .004 - .012 in. (.1 to .3 mm)
NOTE
Throughout piston and connecting
rod reassembly check for freedom of
rotation of the crankshaft.
If
crankshaft does not move freely
CAUTION
recheck bearing size and installation.
Number stamped on rod and cap at
7. INSTALL SUCTION TUBE AND OIL PAN. (REFER
parting line must match and be
TO PAGE 4-57.)
installed towards camshaft side of
engine.
8. INSTALL CYLINDER HEAD. (REFER TO PAGE 4-
h. Alternately tighten rod nuts (3) to pull rod cap (2)
into position.
9. INSTALL ENGINE. (REFER TO PAGE 4-2.)
i.
Torque rod nuts using the following steps:
10. CONNECT NEGATIVE BATTERY CABLE
AT
SHUNT. (REFER TO TM 5-3810-306-20.)
Step 1 = 30 ft-lbs (40 Nm)
Step 2 = 60 ft-lbs (80 Nm)
END OF TASK
Step 3 = 88 ft-lbs (120 Nm)
4-40
