TM 5-3810-306-34
FRONT GEAR COVER INSTALLATION
TOOLS: General mechanic's tool kit: automotive (5180-00-177-7033)
SUPPLIES:
Loctite 277 (Item 164, Appendix B)
Gasket (Item 165, Appendix B)
Copper coat gasket sealer (Item 32, Appendix B)
EQUIPMENT CONDITIONS: Negative battery cable disconnected at shunt.
(Refer to TM 5-3810-306-20.)
Radiator fan and fan guard removed.
(Refer to TM 5-3810-306-20.)
Radiator shroud removed. (Refer to TM 5-3810-306-20.)
Tachometer angle drive removed. (Refer to page 4-56.)
REMOVAL:
1. REMOVE VIBRATION DAMPER (1).
a. Remove four capscrews (2) securing damper to
crankshaft. Do not allow crankshaft to turn.
b. Remove vibration damper (1).
2. REMOVE FRONT GEAR COVER.
NOTE
Front cover does not have to be
removed in order to change front
seal. Proceed to Step C to remove
front seal (8) only.
a. Remove capscrews (3) and (4) securing cover
(5) to gear cover housing (6).
b. Remove cover (5) and gasket (7).
Discard
gasket (7).
c.
Remove front crankshaft seal (8) from front
cover, if necessary.
INSTALLATION:
1. CLEAN ANY GASKET MATERIAL OFF OF COVER
(5) AND HOUSING (6) MATING SURFACES.
4-45
