TM 5-3810-306-34
FRONT GEAR HOUSING INSTALLATION
TOOLS: General mechanic's tool kit: automotive (5180-00-177-7033)
SUPPLIES: Gasket (Item 225, Appendix B)
EQUIPMENT CONDITIONS: Negative battery cable disconnected at shunt.
(Refer to TM 5-3810-306-20.)
Engine removed. (Refer to page 4-2.)
Front gear cover removed. (Refer to page 4-45.)
Fuel Injector pump removed. (Refer to page 5-4.)
Cam shaft removed. (Refer to page 4-41.)
Oil pump removed. (Refer to page 4-59.)
Oil pan removed. (Refer to page 4-57.)
REMOVAL:
1. REMOVE FRONT GEAR HOUSING (3).
a. Remove capscrews (1) and (2).
b. Remove front 'gear housing (3) from
cylinder block.
2. REMOVE AND DISCARD GASKET (4) FROM
CYLINDER BLOCK.
3. IF NECESSARY, REMOVE PLUGS (5) AND (6)
FROM GEAR HOUSING (3).
4. IF FRONT GEAR HOUSING IS BEING
REPLACED, REMOVE TIMING PIN ASSEMBLY
(13). (REFER TO PAGE 4-50.)
INSTALLATION:
1. IF REMOVED, INSTALL PLUGS (5) AND (6) IN
GEAR HOUSING (3).
2. INSTALL FRONT GEAR HOUSING (3).
a. Install new gasket (4), front gear housing
(3) and capscrews (1) and (2). Torque
capscrews (1) and (2) to 18 ft-lbs (24 Nm).
b. Trim gasket (4) flush with oil pan rail.
4-48
