TM 5-3810-306-34
NOTE
If required, bend lockplates back and
loosen
the
turbine
housing
capscrews to better position bearing
housing to install the turbocharger
drain tube.
c. Install drain tube (6) and new gasket (8)
with two bolts (5) torque to 18 ft-lbs (24
Nm).
NOTE
If Note above was used, reposition
turbine housing and torque nuts to
100 in-lbs (11 Nm).
d. Install tube (10) in cylinder block.
e. Connect tubes (6) and (10) with hose (9)
using clamps (7).
CAUTION
Failure
to
prelubricate
the
turbocharger could result in damage
to the turbocharger upon engine
startup.
f. Pour 2 to 3 oz of clean engine oil into oil
inlet fitting on the top of turbocharger (3)
while spinning turbocharger impeller to
distribute oil in bearing.
g. Install oil supply line (4). Tighten fittings
4. INSTALL ENGINE OIL FILTER.
(REFER TO
securely. Torque to 18 ft-lbs (24 Nm).
TM 5-3810-306-20.)
h. Install hose (2) to turbocharger (3) using
5. CONNECT NEGATIVE BATTERY CABLE AT
clamps (1).
SHUNT. (REFER TO TM 5-3810-306-20.)
6. TEST FOR PROPER OPERATION AND
INSPECT FOR LEAKS. (REFER TO
TM 5-3810-306-10.)
END OF TASK
5-12