TM 5-3810-306-34
NOTE
Prior to installation, coat new
preformed packings with clean
hydraulic oil and fitting threads with
Loctite #545.
a. If removed, install hydraulic fittings (12) and new
packings (14) on end of cylinder.
b. Install clamps (8) and (9) and spacer (10) and
secure them with two capscrews (11), washers
NOTE
The wedge shape spacer (10) is
located between two top halves of
clamps and goes between hydraulic
port bosses on rod end of cylinder to
prevent clamp from rotating.
NOTE
The top leg of longer clamp should
face toward outside of the beam
(toward hoses).
CAUTION
Ensure piston side (extend) of
valve. Reversal of port connections
of rod (retract) and piston (extend)
could result in damage to cylinder as
very high pressure will occur.
11-9