TM 55-8145-202-14
Section I. LUBRICATION INSTRUCTIONS
There are no lubrication requirements for the refrigerated container. Refer to the generator set (TM 5-6115-585-12) and
refrigeration unit (TM 9-4110-258-13) for lubrication instructions.
Section II. REPAIR PARTS, TOOLS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT
4-1.
COMMON TOOLS AND EQUIPMENT.
4.1.1
For authorized common tools and equipment, refer to the Modified Table of Organization and
Equipment (MTOE), CTA 5-970, or CTA 8-100, as applicable to your unit.
4.1.2
The General Mechanics Tool Kit (SC 5180-90-CL-N26) will be used for all maintenance tasks. Any
additional tools required for an individual maintenance task will be identified in the setup information
for that task.
4-2.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
4.2.1
The Repair Parts and Special Tools List (RPSTL) (TM 55-8145-202-24P) as well as the Maintenance
Allocation Chart (MAC) (Appendix B) identify any tools and support equipment needed to maintain the
refrigerated container.
4.2.2
There are no special or fabricated tools required to maintain the refrigerated container.
4-3.
REPAIR PARTS.
4.3.1
Any mandatory replacement parts needed for the maintenance tasks are identified in the mandatory
replacement parts list located in Appendix I.
4.3.2
Repair parts are listed and illustrated in the repair parts and special tools list (TM 55-8145-20224P)
covering unit maintenance for this equipment.
Section III. SERVICE UPON RECEIPT
4-4.
SITE REQUIREMENTS.
a. Transport. The refrigerated container is designed for highway, railway and water transport of perishable
materials. Load and transport the refrigerated container only on equipment compatible with MIL-VAN
transport requirements.
b. Fixed Site. When operating the refrigerated container at a fixed site, select an area that is flat, level, and
provides good water drainage away from container. If the refrigeration unit will be powered by an external
electrical source, the refrigerated container must be located within 20 feet (6 m) of the electrical source.
c. Refrigeration Unit. Refer to TM 9-4110-258-13 for applicable refrigeration unit siting requirements.
4-2
