TM 9-3950-253-13&P
0008
SECURE CONTAINER FOR TRANSPORT - Continued
WARNING
DO NOT move vehicle until container is secured.
During these adjustments, personnel are required to work outside the vehicle
where there are several projecting parts, and personnel are required to bend
down. Take care when bending and straightening. A hard hat is required.
Failure to follow these warnings may result in injury to personnel. Seek medical
attention in the event of an injury.
NOTE
Perform steps 2 through 6 for both right and left sides.
2.
At rear of vehicle, remove locking pin (Figure 15, Item 6) and rotate twistlock assembly (Figure 15, Item 3)
up into twistlock housing (Figure 15, Item 1). Install locking pin.
3.
Pull down handwheel locking pin (Figure 15, Item 4) and rotate to position that allows movement of
handwheel (Figure 15, Item 5).
4.
Loosen handwheel (Figure 15, Item 5) to extend anvil (Figure 15, Item 7) into container corner casting
(Figure 15, Item 2). Rotate anvil 90 to position perpendicular with opening in corner casting.
5.
While maintaining anvil (Figure 15, Item 7) position, securely tighten handwheel (Figure 15, Item 5).
6.
Pull down and rotate handwheel locking pin (Figure 15, Item 4) into position between handwheel fingers.
Figure 15. Secure Twistlock Assembly.
03/15/2011Rel(1.10)root(opusualwp)wpno(O582008)