TM 9-3950-253-13&P
FIELD MAINTENANCE
NO HOOK LIFT FUNCTION - ERROR CODE C0
INITIAL SETUP:
Tools and Special Tools
Equipment Condition
Tool Kit, General Mechanic s (WP 0118, Table 2,
Vehicle parked on level ground, in neutral gear
Item 2)
with parking brake applied
(PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P)
References
NOTE
When ignition switch is turned on after battery disconnect switch has been turned off and
back on, error codes 1 and 24 may alternately display for one minute. This error code
indicates that temporary settings were lost while battery disconnect switch was off, and is
consistent with normal operation.
TROUBLESHOOTING PROCEDURE
SYMPTOM
ERROR CODE C0
MALFUNCTION
Faulty control box interface loom.
CORRECTIVE ACTION
1.
Set ignition switch and battery disconnect switch to OFF position (PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P).
2.
Disconnect stowage interface loom from vehicle control box (WP 0070).
3.
Disconnect vehicle wiring harness from stowage interface loom (WP 0070) and connect vehicle
wiring harness to vehicle control box.
4.
Start engine and set MODE switch to AUTO position (PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P).
5.
Fully extend hook arm and middle frame (PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P).
a.
If hook arm and middle frame do not operate correctly, refer to vehicle TM
(PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
b.
If hook arm and middle frame operate correctly, return hook arm to home position and
proceed to Step 6.
6.
Set ignition switch and battery disconnect switch to OFF position.
7.
Disconnect vehicle wiring harness from vehicle control box (WP 0070).
0049-1
03/15/2011Rel(1.10)root(tswp)wpno(T582048)