TM 9-3950-253-13&P
0062
PLS STOWAGE ASSEMBLY INSTALLATION
1.
Install two spacers (Figure 15, Item 5), four bolts (Figure 15, Item 2), washers (Figure 15, Item 4), and new
locknuts (Figure 15, Item 3) on stowage assembly (Figure 15, Item 1).
Figure 15. PLS Spacers.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and
use assistance during procedure. Ensure any lifting device is in good condition and
of suitable load capacity. Keep clear of heavy parts supported only by lifting
device. Failure to follow this warning may result in injury or death to personnel.
Seek medical attention in the event of an injury.
Use extreme caution while installing stowage assembly. Do not allow fingers to
come between stowage assembly and frame during installation. Failure to follow
this warning may result in injury to personnel. Seek medical attention in the event
of an injury.
NOTE
Stowage assembly weighs 640 lb (290 kg).
Hand tighten bolts on installation.
2.
Attach sling and lifting device to stowage assembly.
3.
Use lifting device to install stowage assembly on vehicle.
03/15/2011Rel(1.10)root(maintwp)wpno(M582061)