TM 9-3950-253-13&P
0076
REMOVAL - Continued
2.
Disconnect light connector (Figure 4, Item 4) from vehicle wiring harness (Figure 4, Item 7).
3.
Remove two screws (Figure 4, Item 2), ground wires (Figure 4, Item 3), light (Figure 4, Item 8), and gasket
(Figure 4, Item 9) from slider beam (Figure 4, Item 1).
4.
Remove two screws (Figure 4, Item 6) and mounting plate (Figure 4, Item 5) from slider beam (Figure 4,
Item 1).
Figure 4. Slider Beam Light and Mounting Plate Removal.
NOTE
Perform steps 5 through 8 for both right and left sides.
5.
Disconnect three light connectors (Figure 5, Item 2) from vehicle wiring harness (Figure 5, Item 3).
6.
Remove and discard tiedown straps (Figure 5, Item 7) as required.
7.
Remove locknut (Figure 5, Item 8), bolt (Figure 5, Item 9), and ground wire (Figure 5, Item 10) from slider
assembly (Figure 5, Item 1). Discard locknut.
8.
Remove locknut (Figure 5, Item 4), bolt (Figure 5, Item 5), and light bracket (Figure 5, Item 6) from slider
assembly (Figure 5, Item 1). Discard locknut.
03/15/2011Rel(1.10)root(maintwp)wpno(M582075)