TM 10-3930-641-34-2
TORQUE CONVERTER ASSEMBLY (CONT)
(Sheet 5 of 15)
LOCATION/ITEM
ACTION
REMARKS
3. Bearing (32)
Install in cover assembly with driver. Be sure
bearing is flush with outside surface of cover
assembly.
4. Drive spider (28)
a. Install in housing.
b. Secure with capscrews (29) and washers
(30), torqued to 77-85 lb. ft. (11-12.3 N.m).
5. Housing (33)
Turn housing over.
6. Two retainers (35) and roller
Install.
assembly (36)
7. Turbine (38) and stator (43)
a. Check clearance between turbine and
stator.
NOTE
Difference between diameter of turbine (F)
and diameter of stator (E) must be at least
0.022 - 0.042 in. (0.56 - 1.6 mm) but no more
than 0.048 in. (1.22 mm). Check in several
locations.
TA099244
Go on to Sheet 6
4-31
