TM 10-3930-675-20-2
0114 00-3
TRANSMISSION ASSEMBLY HYDRAULIC HOSES AND PIPES REPLACEMENT - CONTINUED
0114 00
REMOVAL - CONTINUED
INSTALLATION
NOTE
Refer to General Maintenance Instructions (WP 0194 00) for complete instructions on connecting
hydraulic hoses and pipes and applying proper torque.
If adapter fitting and o-ring seal have been removed, perform steps 1 and 2. If not, proceed to step 3.
1.
Apply lubricating oil to new o-ring seal and install on adapter fitting.
2.
Install adapter fitting on transmission.
3.
Connect hose to adapter fitting and route hose to opposite end as indicated on location diagram.
4.
Apply lubricating oil to two new o-rings.
5.
Install hose connection and two o-rings on transmission and secure with fluid passage bolt.
6.
Secure hydraulic hose with new tiedown straps as needed.
7.
Position pipe (8, 9, 10, and 11) to transmission and tighten each of two fitting nuts.
8.
Operate vehicle and check for leaks.
9.
Replace transmission access covers (WP 0135 00).
10.
Return cab to operational position (TM 10-3930-675-10).
11.
Check transmission oil level and add as needed (LO 10-3930-675-12).
END OF WORK PACKAGE
TRANSMISSION ASSEMBLY HOSE
AND PIPE LOCATION DIAGRAM
NO. 1
NO. 7 & NO. 12
NO. 3 & NO. 6
NO. 2, 4 & 5