TM 10-3930-675-20-2
0118 00-3
FRONT AND REAR PROPELLER SHAFTS REPLACEMENT - CONTINUED
0118 00
FRONT PROPELLER SHAFT INSTALLATION
NOTE
•
Perform following steps at rear of front propeller shaft.
•
Ensure that witness marks are alined.
1.
Position propeller shaft (4) to flange of transmission (9).
2.
Install 12 screws (6), new lockwashers (7), and new locknuts (8). Tighten locknuts to 85 lb-ft (115 Nm).
NOTE
Perform following steps at front of front propeller shaft.
3.
Position propeller shaft (4) to studs of parking brake disc (1) of front axle (5).
4.
Install 12 new lockwashers (2) and new locknuts (3). Tighten locknuts to 85 lb-ft (115 Nm).
REAR PROPELLER SHAFT REMOVAL
NOTE
Perform following steps at front of rear propeller shaft.
1.
Remove 12 screws (10), lockwashers (11), and locknuts (12) from flange of propeller shaft (13). Discard lockwashers
and locknuts.
2.
Remove propeller shaft (13) from flange of transmission (9).
9
10,11,12
13
