TM 10-3930-675-20-2
0194 00-2
GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
0194 00
WORK SAFETY - CONTINUED
6.
Always use power tools carefully.
7.
Observe all WARNINGs and CAUTIONS.
CLEANING INSTRUCTIONS
WARNING
Improper cleaning methods and use of unauthorized cleaning liquids or solvents can injure personnel and
damage equipment. To prevent this, refer to TM 9-247 for further instructions.
1.
General. Cleaning instructions will be the same for the majority of parts and components which make up the truck. The
following applies to all cleaning operations:
a.
Clean all parts before inspection, after repair, and before assembly.
b.
Keep hands free of grease which can collect dust, dirt, and grit.
c.
After cleaning, all parts should be covered or wrapped to protect them from dust and dirt. Parts that are subject to
rust should be lightly oiled after cleaning.
2.
Castings, Forgings, and Machined Metal Parts.
a.
Clean inner and outer surfaces with detergent (Item 11, WP 0203 00) and dry with clean rags (Item 22, WP 0203
00).
b.
Remove grease and accumulated deposits with a scrub brush.
WARNING
Compressed air used for cleaning or drying purposes, or for clearing restrictions, should never exceed 30 psi
(207 kPa). Wear protective clothing (goggles/shield, gloves, etc.) and use caution to avoid injury to person-
nel.
c.
Clear all threaded holes with compressed air to remove dirt and cleaning fluids.
CAUTION
DO NOT wash oil seals, electrical cables, and flexible hoses with dry cleaning solvent or mineral spirits.
Serious damage or destruction of material will result.
3.
Oil Seals, Electrical Cables, and Flexible Hoses. Wash oil seals, electrical cables, and flexible hoses with a solution of
detergent (Item 11, WP 0203 00) and water, and wipe dry with a clean rag (Item 22, WP 0203 00).
4.
Bearings. Clean bearings in accordance with TM 9-214.
PRESERVATION OF PARTS
Unpainted metal parts that will not be installed immediately after cleaning may be covered with a thin coat of lubricat-
ing oil (Item 19, WP 0203 00).
PAINTING
1.
On painted areas where paint has been removed, paint in accordance with procedures outlined in TM 43-0139 and TB
43-0209.
2.
For camouflage painting instructions, refer to FM 5-20.
