TM 10-3930-675-20-2 0197 00-4 BOOM AND TOPHANDLER CALIBRATION - CONTINUED 0197 00 CALIBRATION - CONTINUED 8. Boom Calibration, Boom Cylinders (Retracted) (Menu 7 of 10). a. Fully retract and lower boom. b. Raise boom 1/4 inch to pressurize boom cylinders, then release joystick. DO NOT reposition or move joystick again until procedure is completed. c. Allow system and ECS display to stabilize (10 to 20 seconds), then press “Enter”. d. ECS display screen should look like the following: e. Press right arrow button to advance thru remaining calibration menus. 9. Boom Calibration, Boom Cylinders (Extended) (Menu 8 of 10). a. Fully extend and lower boom. b. Raise boom 1/4 inch to pressurize lift cylinders, then release joystick. DO NOT reposition or move joystick again until procedure is completed. c. Allow system and ECS display to stabilize (10 to 20 seconds), then press “Enter”. d. ECS display screen should look like the following: e. Press right arrow button to advance thru remaining calibration menus. 10. Boom Calibration, Load Check (Menu 9 of 10). a. Fully retract boom and raise 1 in (2.5 cm). b. Check ECS display. Actual Load should read “0-100” kg. c. Reposition boom. Actual Load reading should return to “0-100” lbs. after stabilizing. d. Reposition tophandler. Actual Load reading should return to “0-100” lbs. after stabilizing. e. ECS display screen should look like the following: f. Press right arrow button to advance to remaining calibration menus. CALIBR SERVO 7 (10) INIT BY MIN LOAD LE XXX RI XXX XXX XXX CALIBR SERVO 8 (10) INIT BY MAX LOAD LE XXX RI XXX XXX XXX CALIBR SERVO 9 (10) ALLOWED LOAD ACTUAL LOAD L-LC Kg M Kg Range 800-950 Range 500-650