TM 10-3930-675-20-20196 00-4STEERING CALIBRATION - CONTINUED0196 00CALIBRATION - CONTINUED9.SteeringSystemHydraulicandElectricalConnectionsCheck(Menu8of10).a.Pressing value increase “+” button will result in wheel no. 4 (LF) moving to the right and an increase of values onECS display screen.b.Pressing value decrease “-” button will result in wheel no. 4 moving to the left and a decrease of values on ECSdisplay screen. ECS display screen should look like the following:c.3. Press right arrow button to advance thru remaining steering system calibration menus.10.SteeringCylinderNo.4Calibration(Menu9of10).a.Steering cylinders position must be manually checked by measuring cylinder length. Measurement should be takenfrom center-to-center of cylinder mounting pins. Correct length is 31 5/16 inches (796 mm). If length is incorrect,adjust steering cylinder for wheel no.4 (LF) by pressing increase “+” or decrease “-” buttons.b.Press “Enter”.c.Recheck steering cylinder position. Correct length should be 31 5/16 inches (796 mm).d.ECS display screen should look like the following:e.Press right arrow button to advance to remaining steering system calibration menu.11.CalibrationofSteeringSystemCompleted(Menu10of10).a.With all calibration steps complete and corrections or adjustments made, press “Enter” to return to main menu.b.ECS display screen should look like the following:12.Turn off engine and restart to save data.END OF WORK PACKAGECALIBR STEERING8 (10)AXLE 4ANGLE00ADJUST WHEELCALIBR STEERING9 (10)AXLE 4ANGLE00SET WHEELCALIBR STEERING10 (10)STEERING DONEENTERCALIBRATION OFRange 0 +/-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
