TM 10-3930-675-20-2
0195 00-4
TRANSMISSION CALIBRATION - CONTINUED
0195 00
CALIBRATION - CONTINUED
Table 2. Sub Code Identification.
END OF WORK PACKAGE
SUB
CODE
CORRECTIVE ACTION
1
Stop and restart truck if fault code is “0”. Repeat calibration procedure. If failure
continues, transmission maintenance may be required.
2
Stop and restart truck. Ensure transmission shift control lever is in Neutral (N) position.
Repeat calibration procedure.
3
Stop and restart truck. Ensure parking brake is applied. Repeat calibration procedure.
4
Stop and restart truck. Test parking brake operation. If parking brake operates properly,
repeat calibration procedure. If parking brake is not operating properly, service parking
brake. Repeat calibration procedure.
5
Stop and restart truck. Allow transmission to warm to operating temperature. Repeat
calibration procedure.
6
Allow transmission oil to cool by idling engine but not operating transmission. When oil
temperature has cooled, transmission ECM will resume calibration program.
7
Increase engine RPMs. Transmission ECM will resume calibration program when RPMs
are within a specified range.
8
Decrease engine RPMs. Transmission ECM will resume calibration program when
RPMs are within a specified range.
