TM 10-3930-675-20-20196 00-3STEERING CALIBRATION - CONTINUED0196 00CALIBRATION - CONTINUED6.SteeringCylinderNo.2Calibration(Menu5of10).a.Steering cylinders position must be manually checked by measuring cylinder length. Measurement should be takenfrom center-to-center of cylinder mounting pins. Correct length is 34 inches (868 mm). If length is incorrect, adjuststeering cylinder for wheel no.2 (RR) by pressing increase “+” or decrease “-” buttons.b.Press “Enter”.c.Recheck steering cylinder position. Correct length should be 34 inches (868 mm).d.ECS display screen should look like the following:e.Press right arrow button to advance thru remaining steering system calibration menus.7.SteeringSystemHydraulicandElectricalConnectionsCheck(Menu6of10).a.Pressing value increase “+” button will result in wheel no. 3 (LR) moving to the right and an increase of values onECS display screen.b.Pressing value decrease “-” button will result in wheel no. 3 moving to the left and a decrease of values on ECSdisplay screen. ECS display screen should look like the following:c.Press right arrow button to advance thru remaining steering system calibration menus. 8.SteeringCylinderNo.3Calibration(Menu7of10).a.Steering cylinders position must be manually checked by measuring cylinder length. Measurement should be takenfrom center-to-center of cylinder mounting pins. Correct length is 34 inches (868 mm). If length is incorrect, adjuststeering cylinder for wheel no.3 (LR) by pressing increase “+” or decrease “-” buttons.b.Press “Enter”.c.Recheck steering cylinder position. Correct length should be 34 inches (868 mm).d.ECS display screen should look like the following:e.Press right arrow button to advance thru remaining steering system calibration menus.CALIBR STEERING5 (10)AXLE 2ANGLE00SET WHEELCALIBR STEERING6 (10)AXLE 3ANGLE00ADJUST WHEELCALIBR STEERING7 (10)AXLE 3ANGLE00SET WHEELRange 0 +/-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
