TM 10-3930-675-20-20196 00-2STEERING CALIBRATION - CONTINUED0196 00CALIBRATION - CONTINUED3.SteeringSystemHydraulicandElectricalConnectionsCheck(Menu2of10).a.Pressing value increase “+” button will result in wheel no.1 (RF) moving to the right and an increase of values onECS display screen.b.Pressing value decrease “-” button will result in wheel no.1 moving to the left and a decrease of values on ECS dis-play screen. ECS display screen should look like the following:c.Press right arrow button to advance thru remaining steering system calibration menus.4.SteeringCylinderNo.1Calibration(Menu3of10).a.Steering cylinders position must be manually checked by measuring cylinder length. Measurement should be takenfrom center-to-center of cylinder mounting pins. Correct length is 31 5/16 inches (796 mm). If length is incorrect,adjust steering cylinder for wheel no.1 (RF) by pressing increase “+” or decrease “-” buttons.b.Press “Enter”.c.Recheck steering cylinder position. Correct length should be 31 5/16 inches (796 mm).d.ECS display screen should look like the following:e.Press right arrow button to advance thru remaining steering system calibration menus.5.SteeringSystemHydraulicandElectricalConnectionsCheck(Menu4of10).a.Pressing value increase “+” button will result in wheel no. 2 (RR) moving to the right and an increase of values onECS display screen.b.Pressing value decrease “-” button will result in wheel no. 2 moving to the left and a decrease of values on ECSdisplay screen. ECS display screen should look like the following:c.Press right arrow button to advance thru remaining steering system calibration menus.CALIBR STEERING2 (10)AXLE 1ANGLEXXADJUST WHEELCALIBR STEERING3 (10)AXLE 1ANGLE00SET WHEELCALIBR STEERING4 (10)AXLE 2ANGLE00ADJUST WHEELRange 0 +/-5Range 0 +/-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
