TM 10-3930-675-20-2
0197 00-3
BOOM AND TOPHANDLER CALIBRATION - CONTINUED
0197 00
CALIBRATION - CONTINUED
5.
Boom Calibration, Tophandler Tilt Angle (Boom in Raised Position) (Menu 4 of 10).
a.
Raise boom to maximum height, fully retract, and level tophandler with ground.
b.
Allow ECS display to stabilize, then press Enter.
c.
ECS display screen should look like the following:
d.
Press right arrow button to advance thru remaining calibration menus.
6.
Boom Calibration, Retracted Position (Menu 5 of 10).
a.
Raise boom to maximum height and fully retract.
b.
Allow ECS display to stabilize, then press Enter.
c.
ECS display screen should look like the following:
d.
Press right arrow button to advance thru remaining calibration menus.
7.
Boom Calibration, Extended Position (Menu 6 of 10).
a.
Fully extend boom.
b.
Allow ECS display to stabilize, then press Enter.
c.
ECS display screen should look like the following:
d.
Press right arrow button to advance thru remaining calibration menus.
CALIBR SERVO
4 (10)
LIFT
MAXIMUM
TILT ANGLE
XXX
XXX
CALIBR SERVO
5 (10)
BOOM
MIN EXTENSION
XXX
XXX
CALIBR SERVO
6 (10)
BOOM
MAX EXTENSION
XXX
XXX
Range 35-150
Range 400-550
Range 600-800