TM 10-3930-675-24-2
ENGINE ASSEMBLY REPLACEMENT - CONTINUED
0197 00
INSTALLATION
WARNING
Engine weighs 2,070 lb (940 kg). Lifting device must have sufficient capacity to lift engine. Failure to
follow this warning may result in death or injury to personnel.
NOTE
Ensure all bracket mounting, engine mating, and transmission mating surfaces have been cleaned
and are free of old gasket forming compound and gasket material.
Prior to lowering engine into vehicle, ensure flywheel-to-damper plate screw hole is visible
through access hole in flywheel housing.
1.
Install torque converter and damper plates on transmission (WP 0223 00).
2.
Using suitable lifting device and engine lifting fixture, lower engine into vehicle.
3.
Apply coat of silicone gasket forming compound to engine and transmission mating surface.
NOTE
It may be necessary to adjust transmission damper plate by hand to align guide stud with mating fly-
wheel screw hole.
4.
Position engine to allow damper plate guide stud to pass through flywheel-to-damper screw hole and flywheel housing
access.
NOTE
Flywheel and damper plates are secured with 12 screws; final tightening is done after all screws are installed.
5.
Remove guide stud and install screw (41). Tighten screw hand tight.
6.
Bar engine over until next screw hole is visible and install screw (41). Tighten screw hand tight.
7.
Repeat step 6 for remaining screws until 12 screws are installed securing flywheel to damper plate.
8.
Bar engine over clockwise and tighten each screw (41) to 48 lb-ft (65 Nm).
41
0197 00-10
