TM 10-3930-675-24-2
FUEL INJECTOR REPLACEMENT - CONTINUED
0215 00
REMOVAL
NOTE
Due to engine operating characteristics, adjustments, and alignments, mark or tag push rods,
push tubes, crossheads, and injector assemblies for identification as they are removed. If
removed, these items MUST be replaced in original locations during installation.
Some push rods are under compression due to valve position. To relieve spring tension, hold push
rod while rotating crankshaft CLOCKWISE with accessory drive.
1.
Loosen injector and valve adjusting screws (1) and remove push rods (3) and push tubes (2) on cylinder requiring injec-
tor replacement.
1
2
3
2.
Remove crossheads (4) and disconnect injector connector (7).
3.
Remove screw (5) and injector hold-down clamp (6).
4
5
7
6
0215 00-2