TM 10-3930-675-24-2
FUEL INJECTOR REPLACEMENT - CONTINUED
0215 00
REMOVAL - CONTINUED
4.
Using injector tool (8), remove injector (9) from cylinder head.
8
9
INSTALLATION
NOTE
Ensure three new O-rings have been properly installed on injector. O-rings are color coded for loca-
tion as follows: red top, white middle, blue bottom.
1.
Lubricate three new O-rings (10) with clean engine oil.
2.
Position injector (9) in cylinder head injector bore with solenoid valve toward intake port.
3.
Align injector (9) between valve springs.
CAUTION
DO NOT drive injector in by striking solenoid valve area. This can damage solenoid or cause injector
to be out of alignment in bore, which will result in O-ring damage.
4.
Using injector tool (8), seat injector (9) in bore.
8
9
10
0215 00-3