TM 10-3930-675-24-2
TOPHANDLER JUNCTION BOX REPLACEMENT - CONTINUED
0222 00
REMOVAL - CONTINUED
19.
For USMC vehicles, remove four capscrews (38), washers (39), spacers (40), eight O-rings (41), and junction box (3)
from boom. Discard O-rings.
38,39,40,41
3
434-40078
INSTALLATION
1.
For USMC vehicles, install junction box (3) with four capscrews (38), washers (39), spacers (40), and eight O-rings
(41).
2.
For ARMY and RESET vehicles, install four rubber grommets (36) and two brackets (35) in junction box (3) with eight
washers (34), four screws (33), and four new locknuts (32).
3.
For ARMY and RESET vehicles, install two brackets (35), junction box (3), and loop clamp (37) on tophandler with
four washers (31) and screws (30).
4.
Install twistlock indicator light assembly (28) on side of junction box (3) with two washers (27) and screws (26). Also
5.
Push twistlock indicator light assembly cable (29) into junction box (3).
6.
Connect eight wires (25) of cable (29) to connecting points, as noted during removal.
7.
Install fitting (24) in junction box (3) and tighten cap (23).
0222 00-5