TM 10-3930-675-24-2
TOPHANDLER TILT CYLINDER REPLACEMENT - CONTINUED
0255 00
INSTALLATION
WARNING
Tophandler tilt cylinder weighs 115 lb (52 kg). Lifting device must have sufficient capacity to lift cylin-
der. Failure to follow this warning may result in death or injury to personnel.
NOTE
Refer to General Maintenance Instructions in WP 0284 00 for complete instructions on connecting
hydraulic hoses and applying proper torque.
Coat pins with grease before installation.
1.
Using nylon sling and lifting device, position cylinder (4) so upper end of cylinder can be attached to boom.
2.
Install upper end of cylinder (4) on boom with pin (1).
3.
Install new lockwasher (3) and screw (2).
4.
Lower end of cylinder (4) to tophandler.
5.
Install pin (7).
6.
Install new lockwasher (6) and screw (5).
7.
Remove sling and lifting device from cylinder (4).
8.
Connect two hydraulic hoses (8) to cylinder (4).
9.
10.
Start engine (TM 10-3930-675-10), operate tilt cylinders, and check for leaks.
11.
NOTE
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE
0255 00-3/(0255 00-4 Blank)