TM 10-3930-675-24-2
MOUNTING ENGINE ON REBUILD STAND - CONTINUED
0270 00
REMOVAL - CONTINUED
7.
Apply lubricant to two new O-rings (12) and install on coolant filter head (9).
CAUTION
Ensure control valve on coolant filter head is in ON position. Possible engine damage may occur if
valve is not in ON position.
8.
Position coolant filter head (9) with new O-rings (12) on water header plate and install three washers (10) and screws
(11). Tighten screws to 15 lb-ft (20 Nm).
9
10
11
9
12
10
11
9.
Position thermostat housing support (5) with new gasket (4) and install with four screws (2). Tighten screws to 15 lb-ft
(20 Nm). Connect wiring harness to temperature sensor.
2
4
COOLANT
TEMPERATURE
SENSOR
5
0270 00-8