TM 10-3930-675-24-2
IDLER GEARS AND CAMSHAFT DRIVE GEAR REPLACEMENT - CONTINUED
0276 00
INSTALLATION - CONTINUED
2.
Install hydraulic pump idler gear as follows:
CAUTION
To prevent damage to gear and engine during operation, position rear thrust bearing with grooved
side toward idler gear.
a.
Apply a light coating of lubriplate to rear thrust bearing (9) and hydraulic pump idler gear (7).
b.
Install rear thrust bearing (9) and idler gear shaft (8).
CAUTION
To prevent damage to gear and engine during operation, position front thrust bearing with grooved
side toward idler gear.
c.
Install hydraulic pump idler gear (7) and front thrust bearing (9) on idler gear shaft (8).
d.
Install gear retainer (10) and three screws (11). Tighten screws to 45 lb-ft (61 Nm).
e.
Insert spacer (13) and new rectangular seal (12).
9
8
9
7
10
11
13
12
0276 00-11