TM 10-3930-675-24-2
FRONT GEAR HOUSING REPLACEMENT - CONTINUED
0278 00
INSTALLATION - CONTINUED
2.
Install two guide pins in front gear housing end of cylinder block.
CAUTION
Avoid use of excessive amounts of sealant, which could result in blocked oil passages in engine.
NOTE
Sealant requires installation in ten minutes or less. It is best to apply sealant and immediately install
front gear housing.
3.
Apply sealant to areas of front gear housing (4) as follows:
a.
Apply sealant to rear of gear housing, filling groove so 1/16 to 1/8 in. (1.6 to 3.2 mm) is above block mounting sur-
face.
b.
Apply a 1/16-in. (1.6 mm) bead of sealant to oil pan and cylinder block gear housing joint.
c.
Apply additional sealant to area by camshaft opening.
4.
Install front gear housing (4) over guide pins on cylinder block (3) and install 14 flange head screws (2) as noted during
removal.
5.
Remove two guide pins and install two remaining flange head screws (2).
2
2 2
2
3
4
2
2
2
2
0278 00-5