TM 5-3810-306-34
NOTE
e. Install one friction clutch disc (141). Alternate
one steel clutch disc (140) and one friction clutch
The friction discs in the low clutch
disc (141) until all have been installed.
have a higher coefficient rating than
the friction discs in the other
f.
Install clutch plate (139) and retaining ring (138).
clutches, therefore the discs must
not be mixed. The low clutch inner
g. Install retaining rings (133 and 132).
disc can be identified by an X
stamped on one side of the inner
h. Press bearing (131) into position.
Install cup
teeth. The low clutch inner disc also
(130).
has a strip of non-soluble yellow
paint sprayed on the outer edge of
i.
Install gear (125) onto housing shaft (145). Align
the disc.
splines on gear with internal teeth of friction
discs and top gear into position.
d. Install one steel clutch disc (140).
j.
Install retaining ring (123).
k.
Press bearing (122) into position.
7-48
