TM 9-3950-253-13&P
FIELD MAINTENANCE
NO STOWAGE FUNCTION - ERROR CODE 9
INITIAL SETUP:
Tools and Special Tools
Equipment Condition
Tool Kit, General Mechanic s (WP 0118, Table 2,
Vehicle parked on level ground, in neutral gear
Item 2)
with parking brake applied
(PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P)
References
NOTE
When ignition switch is turned on after battery disconnect switch has been turned off and
back on, error codes 1 and 24 may alternately display for one minute. This error code
indicates that temporary settings were lost while battery disconnect switch was off, and is
consistent with normal operation.
TROUBLESHOOTING PROCEDURE
SYMPTOM
ERROR CODE 9
MALFUNCTION
Stowage angle (stowage capture frame position) sensor harness shorted.
CORRECTIVE ACTION
1.
Set ignition switch and battery disconnect switch to OFF position (PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P).
2.
Check stowage angle (capture frame position) sensor for loose or damaged connection.
Tighten or repair angle (capture frame position) sensor connection.
3.
Set battery disconnect switch and ignition switch to ON position.
If error code is still displayed, proceed to Step 4.
4.
Calibrate stowage angle (stowage capture frame position) sensor (WP 0087).
If calibration not successful, proceed to Step 5.
5.
Set battery disconnect switch and ignition switch to ON position.
If error code is still displayed, proceed to Step 6.
6.
Set battery disconnect switch to OFF position.
7.
Disconnect wires from positions 1, 2, and 3 on P5 in Space 4000 ST box.
8.
Connect jumper wire between pins 1 and 2 at connector end of harness and check resistance of
same wires at sensor end of harness.
0033-1
03/15/2011Rel(1.10)root(tswp)wpno(T582032)