TM 9-3950-253-13&P
FIELD MAINTENANCE
STOWAGE ANGLE SENSOR CALIBRATION
INITIAL SETUP:
Tools and Special Tools
References
Tool Kit, General Mechanic s (WP 0118, Table 2,
Item 2)
Equipment Condition
Materials/Parts
Vehicle parked on level ground, in neutral gear
Cap Set, Protective, Dust and Moisture
with parking brake applied
(WP 0120, Table 1, Item 2)
(PLS: TM 9-2320-364-14&P,
Rag, Wiping (WP 0120, Table 1, Item 16)
HEMTT: TM 9-2320-326-14&P)
Tag, Marker (WP 0120, Table 1, Item 20)
Lift frame placed on level ground (WP 0007)
Locknut Qty: 3 (WP 0121, Table 1, Item 15)
Stowage control panel toggle switch set to OFF
position (WP 0004)
Personnel Required
(Two)
WARNING
Lift frame must be placed on solid, level ground.
During these procedures, the operator will be required to climb on and around the
vehicle. Be sure to wear suitable footwear and that no surfaces are slippery. Wear
suitable gloves and hard hat.
Failure to follow these warnings may result in injury or death to personnel. Seek
medical attention in the event of an injury.
INTRODUCTION
This procedure calibrates the operating range of the stowage angle sensor.
END OF TASK
0087-1
03/15/2011Rel(1.10)root(maintwp)wpno(M582086)