TM 9-3950-253-13&P
0086
CLEANING AND INSPECTION
Clean and inspect all parts IAW (WP 0061), General Maintenance Instructions.
END OF TASK
INSTALLATION
WARNING
During these procedures, the operator will be required to climb on and around the vehicle.
Be sure to wear suitable footwear, ensure no surfaces are slippery, wear suitable gloves
and hard hat and maintain three points of contact to the vehicle. Failure to follow this
warning may result in injury to personnel. Seek medical attention in the event of an injury.
NOTE
Perform steps 1 and 2 for PLS M1075 trucks.
Perform steps 3 thru 5 for PLS M1075A1 trucks.
PLS Stowage Control Unit and Bracket Installation
1.
Install stowage control unit (Figure 5, Item 2), four washers (Figure 5, Item 3), and bolts (Figure 5, Item 4)
on stowage control unit bracket (Figure 5, Item 1).
2.
Install stowage control unit bracket (Figure 5, Item 1), two washers (Figure 5, Item 6), bolts (Figure 5,
Item 5), washers (Figure 5, Item 7), and new locknuts (Figure 5, Item 8) on platform (Figure 5, Item 9).
Figure 5. PLS M1075 Stowage Control Unit Installation.
03/15/2011Rel(1.10)root(maintwp)wpno(M582085)