TM 9-3950-253-13&P
0086
REMOVAL
Stowage Control Unit Harness Removal
WARNING
During these procedures, the operator will be required to climb on and around the vehicle.
Be sure to wear suitable footwear, ensure no surfaces are slippery, wear suitable gloves
and hard hat and maintain three points of contact to the vehicle. Failure to follow this
warning may result in injury to personnel. Seek medical attention in the event of an injury.
NOTE
Tag wires and connectors to aid in installation.
Note routing of wires and harnesses to aid in installation.
Remove and discard tiedown straps as required.
1.
Loosen four bolts (Figure 1, Item 1) and remove cover (Figure 1, Item 2) from stowage control unit (Figure 1,
Item 3).
2.
Remove yellow, orange, red, and brown wires (Figure 1, Item 11) from connector P1 (Figure 1, Item 12) in
stowage control unit (Figure 1, Item 3).
3.
Remove CAN bus wiring harness (Figure 1, Item 8) from stowage control unit (Figure 1, Item 3).
4.
Remove blue, brown, and black wires (Figure 1, Item 4) from connector P9 (Figure 1, Item 5) in stowage
control unit (Figure 1, Item 3).
5.
Remove LH twistlock wiring harness (Figure 1, Item 10) from stowage control unit (Figure 1, Item 3).
6.
Remove blue, brown, and black wires (Figure 1, Item 7) from connector P10 (Figure 1, Item 6) in stowage
control unit (Figure 1, Item 3).
7.
Remove RH twistlock wiring harness (Figure 1, Item 9) from stowage control unit (Figure 1, Item 3).
0086-2
03/15/2011Rel(1.10)root(maintwp)wpno(M582085)