TM 9-3950-253-13&P
0062
PLS STOWAGE ASSEMBLY REMOVAL
WARNING
Disconnecting quick disconnect fittings will not relieve hydraulic system pressure.
Use extreme caution when disconnecting hydraulic hoses. Contact with hydraulic
oil can damage eyes and skin. Wear eye protection, gloves, and protective clothing
while removing hydraulic hoses.
Hydraulic fluid under pressure can penetrate the skin and cause injury, blindness,
or death. Pressure may build up in a hydraulic system. DO NOT perform any
hydraulic system service without first shutting down the engine to relieve system
pressure.
Any fluid spilled can cause a slip hazard and must be cleaned up immediately.
Failure to follow these warnings may result in death or serious injury to personnel.
Seek medical attention in the event of an injury.
NOTE
Tag and note position of all hoses and fittings to aid in installation.
Cap all hoses and fittings on removal to prevent contamination.
Place a drain pan under components as required to catch any draining hydraulic
fluid.
Remove and discard tiedown straps as required.
1.
Loosen three locking pins (Figure 5, Item 1), and remove manifold cover (Figure 5, Item 2) from stowage
assembly (Figure 5, Item 7).
2.
Disconnect two hydraulic hoses (Figure 5, Item 3) from manifold (Figure 5, Item 4) and route to under
stowage assembly (Figure 5, Item 7).
3.
Disconnect pneumatic line (Figure 5, Item 5) from solenoid valve (Figure 5, Item 6) and route to under
stowage assembly (Figure 5, Item 7).
0062-6
03/15/2011Rel(1.10)root(maintwp)wpno(M582061)