TM 9-3950-253-13&P
0080
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Do not
allow fingers to come between rear slider bed and roller assembly during installation.
Failure to follow this warning may result in injury or death to personnel. Seek medical
attention in the event of an injury.
NOTE
Rear slider bed weighs 190 lb (86 kg).
Perform steps 1 through 11 for both right and left sides.
1.
Attach sling and lifting device to rear slider bed (Figure 4, Item 8).
2.
Use lifting device to remove slack from sling.
3.
Install shim (Figure 4, Item 6) and two bearings (Figure 4, Item 7) in rear frame (Figure 4, Item 1).
4.
Use lifting device to install rear slider bed (Figure 4, Item 8) on rear frame (Figure 4, Item 1).
5.
Install shim (Figure 4, Item 2), end plate (Figure 4, Item 3), two washers (Figure 4, Item 4), and bolts
(Figure 4, Item 5) on rear frame (Figure 4, Item 1).
6.
Remove lifting device and sling from rear slider bed (Figure 4, Item 8).
7.
Apply grease to fitting (Figure 4, Item 9).
Figure 4. Rear Slider Bed Installation.
03/15/2011Rel(1.10)root(maintwp)wpno(M582079)