TM 10-3930-675-20-2
0101 00-1
HYDRAULIC RESERVOIR AND LIFT CYLINDER SENSORS REPLACEMENT
0101 00
THIS WORK PACKAGE COVERS
Temperature Sensor Replacement
Pressure Sensor Replacement
Lift Cylinder Sensor Replacement
INITIAL SETUP
Tools and Special Tools
Tool kit, general mechanics (Item 31, WP 0204 00)
Wrench, torque, 15-75 lb-ft capacity (Item 42, WP
0204 00)
Materials/Parts
Cap set, protective (Item 4, WP 0203 00)
Grease, electrically conductive (Item 17, WP 0203 00)
Oil, lubricating (Item 19, WP 0203 00)
Rag, wiping (Item 22, WP 0203 00)
Strap, tiedown (Item 27, WP 0203 00)
References
WP 0184 00
WP 0197 00
Equipment Condition
Hydraulic system pressure relieved (WP 0164 00)
Master battery switch in OFF position
WARNING
DO NOT disconnect or remove any hydraulic system line or fitting unless hydraulic system pressure
has been relieved. Tighten all connections before applying pressure. Escaping hydraulic fluid under
pressure can penetrate the skin, causing serious injury.
Search for leaks with a piece of cardboard. Protect hands and body from high-pressure fluids. If an acci-
dent occurs, see a doctor immediately. Any fluid injected into the skin must be surgically removed
within a few hours or gangrene may result.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing switches.
Hydraulic fluid is very slippery. Immediately wipe up any spills. Failure to follow this warning may
result in injury to personnel.
CAUTION
Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all openings after dis-
connecting. Contamination of hydraulic system could result in equipment failure.
NOTE
Remove and discard tiedown straps.
Apply electrically conductive grease to connectors before connections are made.
