TM 10-3930-675-24-2
ENGINE MOUNTS AND LIFTING BRACKETS REPLACEMENT - CONTINUED
0198 00
LIFTING BRACKETS INSTALLATION
CAUTION
DO NOT use or install a cracked, bent, or otherwise damaged lifting bracket. Do not weld a cracked
bracket. Doing so may cause severe equipment damage during lifting operations.
NOTE
Ensure lifting brackets are not cracked or bent and are clean and free of dirt.
1.
Position front lifting bracket (2) and secure with four screws (1). Tighten screws to 35 lb-ft (47 Nm).
2.
Position rear lifting bracket (3) and secure with two screws (4). Tighten screws to 60 lb-ft (81 Nm).
2
3
1
1
4
5
3.
Install access covers (WP 0142 00).
4.
Return cab to operational position (TM 10-3930-675-10).
5.
Install engine cover (WP 0148 00).
FRONT ENGINE MOUNT REMOVAL
CAUTION
Position trestle under front of engine to assist with supporting weight while front engine mounts are
not in place. DO NOT, however, position trestle under oil pan. Damage to oil pan may result.
1.
Position suitable lifting device and attach to engine front lifting bracket (2).
NOTE
Right- and left-front engine shock mounts are removed in the same manner. Perform steps 2 thru 5 on
both front engine shock mounts.
2.
Loosen two jamnuts (14) and adjusting screws (13).
NOTE
Adjust lifting device to support weight of engine without applying tension on mounting hardware.
0198 00-2
