TM 5-3810-306-34
OUTRIGGER JACK CYLINDER INSTALLATION
TOOLS: General mechanic's tool kit: automotive (5180-00-177-7033)
Tool Outfit Hyd System, Test and Repair, 3/4 Ton Trailer Mtd
Tool Kit Auto-Fuel and Electric System Repair (5180-00-754-0655)
Shop Equipment Auto-Maintenance and Repair; Org Suppl No 1
Lifting device (500 lbs capacity)
SUPPLIES:
Preformed packing (Item 67, Appendix B) (2 Required)
Preformed packing (Item 68, Appendix B) (2 Required)
Wear ring (Item 69, Appendix B)
Weatherstrip adhesive (Item 70, Appendix B)
Cotter pin (Item 10, Appendix B) (2 Required)
EQUIPMENT CONDITIONS: Negative battery cable disconnected at shunt.
(Refer to TM 5-3810-306-20.)
REMOVAL:
1. REMOVE JACK CYLINDER (1).
a. Remove jack cylinder access cap (2).
b. Tag and disconnect hydraulic lines (3) from jack
cylinder. Remove and discard packings (8).
Cap or plug lines.
c.
Remove two fittings (4) from jack cylinder ports.
Remove and discard packings (9). Plug cylinder
ports.
d. Place a hydraulic jack under jack cylinder. Raise
jack cylinder to relieve weight from pin (6).
e. Remove cotter pins (5) and pin (6) securing jack
cylinder (1). Discard cotter pins (5).
f.
Using hydraulic jack, raise cylinder up until a
lifting device can be attached to cylinder (1).
g. Using lifting device, remove cylinder from beam.
h. In bottom of cylinder tubes remove and discard
wear ring (7).
11-15
