Table 2. Error Code 1132 - Throttle Position Sensor Circuit Failure Troubleshooting Procedures.

Error Code 1131 - Throttle Position Sensor Circuit Failure - Continued - TM-10-3930-675-20-1_200

Error Code 1132 - Throttle Position Sensor Circuit Failure - Continued - TM-10-3930-675-20-1_202

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
173

TM 10-3930-675-20-1 0008 00-9 ENGINE TPS AND IDLE VALIDATION SWITCH TROUBLESHOOTING - CONTINUED 0008 00 Table 2. Error Code 1132 - Throttle Position Sensor Circuit Failure Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1132 - Throttle Position Sensor Circuit Failure 1. Place ignition switch to OFF position and disconnect harness from throttle position sensor. a. Inspect harness connector and throttle position sensor connector for dirty, corroded, bent, broken, pushed back, and extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check harness and throttle position sensor for dirt or moisture in or on connector and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 2. Place ignition switch to OFF position and disconnect harness from throttle position sensor. Perform the following resistance checks. a. Measure resistance between throttle position sensor connector X690 pin 5 and pin 6 with pedal released. Resistance should be 2000-3000 ohms. If resistance is not as specified, replace throttle position sensor (WP 0061 00). PIN 6 PIN 5 USE TEST LEAD KIT P/N 3823996 X690 1 OR 2 GN 3 BU BK 6 RD 5 WH 4 2000-3000 OHMS

Privacy Statement
Press Release
Contact