TM 10-3930-675-20-1
0008 00-10
ENGINE TPS AND IDLE VALIDATION SWITCH TROUBLESHOOTING - CONTINUED
0008 00
Table 2. Error Code 1132 - Throttle Position Sensor Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1132 - Throttle Position Sensor
Circuit Failure - Continued
b. Measure
resistance
between X690 pin 5 and
ground
with
pedal
depressed and released.
Resistance
should
be
greater than 100k ohms.
If resistance is not as specified,
replace throttle position sensor
(WP 0061 00).
3. Place ignition switch in OFF
position
and
disconnect
harness from throttle position
sensor.
4. Measure
resistance
from
signal pin of throttle position
sensor to chassis ground.
Resistance should be greater
than 100k ohms.
If resistance is not as specified,
replace throttle position sensor
(WP 0061 00).
PIN 5
USE TEST LEAD KIT P/N 3823996
X690
1 OR
2 GN
3 BU
BK 6
RD 5
WH 4
>100K OHMS
